Welcome to our brand new website! If you created an account on our old website it was not transferred. Please create a new account.
Have a question or need help?We are open M-F 10a-6p & Saturday 10a-3p CSTVisit our store at 8153 Big Bend Blvd. Webster Groves, Missouri 63119
Welcome to Krueger Pottery Supply!
Olympic Kiln Vents and Accessories
Used to protect kiln shelves and kiln floor when firing glaze or glass items directly on shelf. Mix with water to the consistency of a thin pancake batter. Apply a thin coating (approximately 1/16") to kiln shelves and floor. Use on cordierite and CoreLite shelving. Not for use on smooth ceramic fiber board shelves, kiln walls, elements or lid.
Observation (Peep) Hole Plugs
Raku tongs are used to remove red hot pottery from the kiln during the raku firing process.
The Analog Pyrometer with Type K thermocouple is used to indicate temperature in the Electric, Glass and Gas kilns. The Analog Pyrometer with a 5-6" thermocouple is used in standard size electric and gas kilns (electric up to 30H oval & Raku & Torchbearer gas kilns). The Analog Pyrometer with a 10" thermocouple is used in the large capac...
An Electronic Wall unit changes a manual kiln (kiln sitter or pyrometer) to an electronic controlled kiln or can be purchase with a new kiln for individuals who prefer the having the controller on the wall instead of the kiln. The wall unit is placed on the wall away from the kiln and is connected to the power cord or wiring of the kiln. The ...
Electro Sitter will replace your obsolete kiln sitter model! The Electro Sitter comes complete with electronic controller of your choice for cone-fire or ramp/hold programming, an attached Type K thermocouple, ceramic fiber, and electronic controller manual.
Installation is easy. The Electro Sitter will fit where the kiln sitter/timer is attac...
The VentMaster Expansion Kit allows two electric kilns to run off the same vent.
During operation, the Kiln Vent system keeps the kiln under a slight negative pressure. This pulls the fumes out of the kiln and pulls in a small amount of fresh air. Firing times are essentially the same. The fumes are exhausted directly into a duct system and removed from the kiln room. Improved airflow in the kiln results in more uniform temp...
A Lid Lift Assist is available for smaller Studio Electric and Glass Kilns - 18" wide or smaller and Medallion models when placing your order. Models 20" and wider are equipped with a Lid Lift Assist. The Lid Lift makes even the heaviest kiln lid easy to open.
Olympic's Lid Lift Assist is designed so that there isn't any stress on the kiln lid...
Lid Wedge is used for venting the kiln. The lid wedge is not used with HotBoxes because the kilns are sectional and the entire lid can be removed nor is the wedge used with the Oval or large Square glass fusing kilns because lid damage will occur.
Heavy duty heat resistant gloves.
The Digital Pyrometer with Type K thermocouple is used to indicate temperature in the Electric, Glass and Gas kilns. The Digital Pyrometer with a 5-6" thermocouple is used in standard size electric and gas kiln (electric up to 30H oval & Raku & Torchbearer gas kilns). The Digital Pyrometer with a 10" thermocouple is used in the large cap...